Superfun S10Pro Electric Scooter with Seat: Unboxing, Features, and Setup

The Superfun S10Pro Electric Scooter with Seat is a versatile and user-friendly electric scooter designed for urban commuters and casual riders alike. Its sleek design, powerful battery, and convenient features make it an attractive option for those seeking an eco-friendly mode of transportation.

In this article, we will explore the unboxing, specifications, and setup process of the Superfun S10Pro to help you get the most out of your new ride.

1.Package Contents of E Scooter with Seat

Assembled S10 Pro
USER MANUAL
Accessories:Hexagon Wrench x 1、Screw × 4、Charging Adapter × 1

Carefully check package contents, if anything is missing or damaged, please contact online customer service for support.

2.Specifications of Sit Down Electric Scooter

Performance index 1:Dimensions

  • Item:L × W × H [1] (inch)
  • Specifications:47.24x6.02x20.39

  • Item:After folding: L × W × H (inch)
  • Specifications:44.49x17.13x23.62

Performance index 2:Weight

  • Item:Item weight (lb)
  • Specifications:Approx. 28

Performance index 3:Riding requirements

  • Item:Load range (lb)
  • Specifications:66~220

  • Item:Age
  • Specifications:14~60

  • Item:Body length (inch)
  • Specifications:47.2–78.7

Performance index 4:Main parameters

  • Item:Max. speed (Mph)
  • Specifications:Approx. 19

  • Item:General range[2] (Mi)
  • Specifications:Approx. 25

  • Item:Max. climbing angle (%)
  • Specifications:Approx. 15

  • Item:Suitable surfaces
  • Specifications:Cement, asphalt and mud roads; bench lower than 1cm; crevice narrower than 1.2 inch

  • Item:Operating temperature (°F)
  • Specifications:14–104

  • Item:Storage temperature (°F)
  • Specifications:-4–113

  • Item:IP rating
  • Specifications:IPX5

Performance index 5:Battery pack

  • Item:Rated voltage (VDC) Max.
  • Specifications:36

  • Item:input voltage (VDC)
  • Specifications:42

  • Item:Rated capacity (WH)
  • Specifications:375wh

  • Item:Intelligent battery management system
  • Specifications:Unusual temperature/short circuit/under voltage/over current/dual overcharge/dual over-discharge protections

Performance index 6:Tires

  • Item:Front tire
  • Specifications:10" Solid rubber

  • Item:Rear tire
  • Specifications:10" Solid rubber

Performance index 7:Charging adapter

  • Item:Input voltage (VAC)
  • Specifications:100–240

  • Item:Output voltage (VDC)
  • Specifications:Output voltage (VDC)

  • Item:Charging time (h)
  • Specifications:Approx. 5
[1] Item height: from the ground to the top of the scooter;
[2] General range: measured when it is no wind and at 86F, the scooter's fully charged to ride at a even speed of 14.43 mph on a flat surface with a load of 165 pounds.
  • Note 1: Data and specifications may vary due to different models, and are subject to change without notice.

  • Note 2:Typically, a fully charged battery should retain power for 120-180 days. A low-power battery should retain power for 30-60 days. Remember to charge the battery after each use.Completely draining the battery may cause permanent damage to the battery.

  • Note 3:Electronics inside the battery record the charge-discharge condition of the battery; damage caused by over-charging or under-charging will not be covered by the Limited Warranty.

3.How to Use the Control Panel and Button?

The power level is indicated by five power lights on the control panel.
As power is consumed, the lights will change from solid to flashing, and finally turn off from up to down. When the bottom power light flashes, it indicates low power. Please recharge soon for further use. After running out of power, all lights will turn off, and the scooter will coast until it comes to a complete stop.

Use the button:
  • Press and hold the button for 2s to tur on/off the scooter;

  • After turning  on,one-click the power button to convert riding mode(1gear=10mph,2  gear=15mph,3 gear=18.64mph);

  • Quickly two-click the power button to turn on/off the headlight;

  • Quickly press three times to change the unit between MPH and KMPH.

4.Assembly and Set-Up

  • A.Fasten the handlebar stem on the headset, and put the kickstand down;
  • B.Attach the handlebar to the stem;
  • C.Tighten the screws onto both sides of the stem with the hexagon
  • wrench;
  • D.After the assembly, press the power button to check if it's working properly.
  • The charger must be unplugged before turning on.
Conclusion
The Superfun S10Pro electric scooters for adults with seat offers a seamless blend of performance, convenience, and style. Its robust specifications, combined with easy assembly and intuitive controls, make it a top choice for anyone looking to enhance their commuting experience. With proper care and maintenance, this sit down electric scooter for adults promises to be a reliable and enjoyable mode of transportation for years to come.

Dejar un comentario

Este sitio está protegido por hCaptcha y se aplican la Política de privacidad de hCaptcha y los Términos del servicio.